injection volume

The sensitivity of capillary electrophoresis is greatly limited due to the small injection volume and the short optical path length .

由于毛细管进样体积小以及在柱检测光程短，极大地限制了毛细管电泳检测灵敏度的提高。

This method has overcome the problems of slow analysis procedure , large sample consume amount , complex operation and error easily caused by manual injection speed and injection volume in traditional interval hydride generation atomic absorption spectrometry .

本法克服了传统的间断氢化物发生原子吸收光谱法分析速度慢、样品耗量大、操作繁琐且因手工进样在进样速度和进样体积上容易带来误差等缺点。

However , the elevation of injection volume increased the transformation rate .

而注射量的加大能提高转化率。

Mould - filling test analysis and the limiting injection volume

注射成型充型试验分析与极限注射量

The study of the relationship between PMMA injection volume and effect in percutaneous vertebroplasty

经皮穿刺椎体成形术骨水泥注射量与疗效关系的研究

This relationship can be used to determine steam injection volume and the production distribution during steam stimulation .

利用这一线性关系，以油藏的油汽比确定注汽量，可解决稠油蒸汽吞吐阶段的配产问题；

Experimental study about insertion depth and injection volume of 16F balloon urinary catheter

16F气囊尿管插入深度和注水量的实验研究

The principle and application result of DSC reveal that oxygen activation log is a univariable function of injection volume .

从该仪器的原理和应用结果看，氧活化测井曲线只与注入量有关。

When the injection volume exceeded to 100 % , the blood flow and the survival length of the expanded flap decreased .

尤其是超量注水100%后，皮肤的血流量和皮瓣的成活长度反而下降。

Combined with control characteristics of engine air fuel ratio , the CMAC controller which is self adaptive to compensate fuel injection volume is studied .

结合发动机空燃比的控制特征，研究了一种能自适应补偿喷油量的CMAC控制器。

Injection volume , response , repeatability , linearity and limit of detection of the instrument are researched in analyzing pesticide residues .

主要研究了“胃袋式”大体积装置的进样量、响应值、重复性、线性和检测灵敏度等性能。

The form mechanism and properties of gel in delayed crosslink - ing system , and system injection volume and manner are discussed in this paper .

本文对延缓交联体系的凝胶形成机理、性质以及该体系的注入量和注入方式进行了研究。

By using the simulated value of modeling , the relation of water injection volume and maximum horizental distance of moisture frontal are concluded .

利用模型的计算结果得出了单坑注水量与湿润锋最大水平推进距离之间的关系，并据此确定了坑距。

Conclusion To increase AHS injection volume can obviously enlarge the destruction zone by single RFA in ex vivo bovine liver .

结论增加AHS注射剂量可以明显增大离体牛肝RFA一次性毁损体积。

In range analysis , the sequence of the effective factors is part thickness , melt temperature , injection volume , injection pressure , mold temperature and injection rate .

在极差分析中各个因素的影响顺序为塑件厚度、熔体温度、注射量、注射压力、模具温度、注射速度。

Objective To investigate the optimal insertion depth and injection volume in urethral catheterization with 16F balloon urinary catheters .

目的探讨16F气囊尿管插入合适长度和注水量。

With the consistency coefficient , power law index , melt injection volume , injection speed , injection time delay increased , the inlet pressure also increased . 4 .

随着稠度系数、幂率指数、熔体注射量、注水速度、注水延时的增加，入口压力也增加。

The sensitivity analysis indicates that the parameters impacting the production results from high to low are production time , steam dryness , cyclic steam injection volume , steam injection pressure .

敏感性分析表明，蒸汽参数对开发效果影响的顺序从大到小依次为生产时间、注汽干度、周期注汽量、注汽压力、焖井时间和注汽速度；

A method using SCS model for determination of daily water injection volume is applied in chengdu city landfill test to supply the precipitation-runoff and initial abstraction in laboratory simulation .

针对填埋场室内模拟试验往往忽略降雨径流和初损的问题，提出运用SCS模型确定室内模拟试验日注水量的方法，并将计算结果应用于成都长安填埋场室内模拟试验中。

This paper presents the composition of EMS hardware and the main functions of control modules including the management control of fuel injection volume , management control of engine ignition and some reserved functions .

介绍了德尔福摩托车EMS的硬件构成和控制模块的主要功能，包括燃油喷射量管理控制、发动机点火管理控制和一些储备功能。

It is highly recommended to use the foaming agent solution with concentration of 0.05 % of foaming agent , injection volume of 0.2 PV and nitrogen injection volume of 0.2 PV .

建议现场施工中使用泡沫剂A含量为0.5%的泡沫剂溶液，注入量0.2PV，氮气注入量也是0.2PV较适宜。

Methanol injection volume should be adjusted in time according to the production condition , which could save production cost , and the injected methanol should be recycled and regenerated in consideration of environment protection .

甲醇注入量要根据生产状态及时调整，以节约生产成本，采用集中注醇的同时还要集中回收再生，保护环境。

Material and Method : 231 cases enhanced scanning of liver were performed and the injection volume of contrast agent is 1.2mL/kg with the rate of 2.5 ml / s ~ 3.0mL/s .

材料与方法231例患者行肝脏增强扫描，对比剂的用量为1.2ml/kg，注射流率为2.5ml/s～3.0ml/s。

It put forward the improvement direction of the gas collecting container , explains the measuring and calculating method of injection volume , establishes dynamic injection volume measuring device of the injector , introduces the structure and working process of the measurement system .

阐述了喷气体积的测量与计算方法。建立了喷嘴动态喷射体积测量装置，分析了测量系统结构及工作过程。

The experiment results revealed the concentration and injection volume of calcium chloride solution , injection volume of ginger juice , the concentration of papain solution and treating time significantly affected the tenderness of beef ( P < 0.05 ) .

试验结果表明：氯化钙溶液的浓度和注射量、生姜汁的注射量、木瓜蛋白酶溶液的浓度和处理时间显著影响牛肉的嫩度（P<0.05）。

The result shows that the change of pressure of working air has a little influence on injection volume , that properties will not decrease greatly while working pressure varies , and that operating parameters has great influence on structure of wave system of ejector .

结果表明，工作气体的变化对引射流量的影响较小，当工作压力波动时不会引起性能急剧下降，操作参数与几何参数对喷射器的波系结构影响很大。

The optimization parameters are production time 60d , steam dryness fraction 70 % , cyclic steam injection volume 2 210 t , and steam injection pressure 4.0 MPa , stew time 3d , and steam injection velocity 220 t / d.

优化结果为：生产时间60d，注汽干度70%，周期注入量2210t，注汽压力4.0MPa，焖井时间3d，注汽速度220t/d。

There were 12.8 % acidic oligosaccharides in hydrolysate , eluted with the soluble xylan of DP > 8 together . Using the proper elution flow rate and injection volume at 800 ? mL / h and 120 ?

酶解液中含有12.8%的酸性低聚糖，在洗脱时和木八以上的可溶性聚糖混合在一起。

According to the principle , this article examines relative process used in gas gathering station using initial pressure energy of natural gas for throttling temperature reduction and gives a calculation method of injection volume of methanol to inhibit formation of hydrate during throttling temperature reduction .

本文运用这一原理，研究利用天然气原始压力能，实现节流降温在集气站所采用的工艺流程，给出了在节流降温过程中，不形成水化物所需的甲醇注入量的计算方法。

However , the concentration limits of detection of MCE are often inadequate for the measurement of low concentration sample , because of the characteristically low injection sample volume , short optical path length and short separation distance .

然而，由于进样体积少、光程距离较短，检测灵敏度不足以满足低浓度样品的分析需要。